Verify your email, you are one step away from completing the registration
We've sent you an email to confirm your account.
Check your inbox and follow the instructions to activate it.
Close
Recover password
Close
You have registered successfully
Check your inbox to confirm your account
Close
Verification
Session not started. Please log in manually.
Close
Download
You will be able to start the download once the mandatory fields are completed
Close
Download
You will be able to start the download once the mandatory fields are completed
The perfect leveling for your floor and wall coverings.
ATRIM - NIVELATOP Calculator
Calculate with precision. Install with confidence.
A technical tool for estimating the amount of materials needed for the proper installation of floor and wall coverings.
Complete these 4 steps and we'll put together your self-leveling kit, with the exact quantities for your project.
Before you start calculating, define the basis of your project
The calculated quantity is an estimate per m². There may be variations depending on the geometry of the area to be covered.
Important: If you choose the clip and wedge system for the installation of tiles with a thickness less than 7 mm, the use of leveling bases is mandatory when using gray, yellow or red clips, to ensure correct installation. In addition, for the bolt-and-nut system, the use of leveling pads is recommended in all cases to ensure an optimal finish.
Step 1/4
1Porcelain or ceramic thickness
milimeters
Step 2/4
2Clip Selection
Depending on the thickness of the selected coating/ceramic or porcelain tile, the Self-Leveling Clips available are the following:
Choose a clip model.
Leveling clip Translucent 1/16 (100-unit packs)
SKU: 5292
Leveling clip Yellow 3/32 (100-unit packs)
SKU: 5193
Leveling clip Red 1/8 (100-unit packs)
SKU: 5194
The choice of the thickness of the Self-Leveling Clip determines the space between the coatings.
Important: For rectified porcelain tiles, a minimum joint space of 1.5 mm must be left between coverings. For other types of plates, it is recommended to consult the manufacturer since the space may vary depending on their technical specifications and surface conditions.: